If you prefer The Shed’s new uploads to its website to come to you rather than you to come and keep checking what’s new, then good news.
There is now an RSS button on the site so you can keep right up to date and never miss out on a good yarn or some great advice.
Sign up today with your favourite RSS feed application.

Welding: Standing to attention – lathe bench build part 2
I ordered some drawer slides of the appropriate length (350mm) and worked out the width of the slides and thus the width of the drawers. The drawer slides are rated at 45kgs. I couldn’t be sure what weight I would be likely to load but this should suffice. I elected to run with eight drawers and make the second opening in the frame a cabinet to house larger components like the four-jaw chuck. After some fiddling I settled on two drawers each of 75mmx70mmx60mm, and 50mm high, separated by 10mm.
I bought three sheets of cold rolled steel 1mm thick. This is within the limits of the panbrake and I had hoped the material would be stiff enough given that the drawer had to span over 500mm width. I broke the material down into half sheets to make it easier to handle.